凯创交换机端口镜像设置

作者：易隐者发布于：2012-5-12 17:10 Saturday 分类：参考资料

凯创产品在实际工作环境中较为少见，但正因为少见，在遇到时，一旦需要做端口镜像的设置，往往难以找到相关的资料，下面为我个人在网上搜寻的相关资料的总结。

Matrix E1

前面板上的端口每8个端口被分成6组，每各扩展槽上的模块有2组，因此，Matrix E1（1H582-51）最多支持12个端口组。Matrix E1（1H582-25）最多支持5个端口组。
Matrix E1上的端口镜像功能只能在端口组织间完成，组内的端口之间不能做端口镜像。
每个端口组中只有一个port可以成为source port或target port。
支持多对一的端口镜像。
Matrix>set port mirroring {disable | enable | source_port target_port}
— 用于建立端口之间的镜像关系或打开/关闭镜像功能
— Matrix>set port mirroring fe.0.4 fe.0.11
— Matrix>set port mirroring disable
Matrix>clear port mirroring source_port
— 用于清除端口间的镜像关系
— Matrix>clear port mirroring fe.0.4

Ssr8000

SSR Command Line Interface Reference Manual 551
port mirroring
Command
Purpose
Apply port mirroring to one or more target ports on an SSR or to traffic specified by an
ACL profile.
Format
port mirroring monitor-port target-port |target-profile name>
Mode
Configure
Description
The port mirroring command allows you to monitor via a single port the activity of one
or more ports on an SSR or the traffic that is specified by an ACL.
Parameters
monitor-port
The port you will use to monitor activity.
target-port
The port(s) for which you want to monitor activity. You can specify a single port or a
comma-separated list of ports.
target-profile
The name of the ACL that specifies the profile of the traffic that you want to
monitor. The ACL must be a previously created IP ACL. The ACL may contain
either permit or deny keywords. The port mirroring command only looks at the
following ACL rule parameter values: protocol, source IP address, destination IP
address, source port, destination port, and TOS.